Bench mode with DFOX
Looking for a tool for complete ECU management in BENCH MODE?
DFOX is the professional tool for you.
Working in BENCH MODE with DFOX
Bench mode is a simple and innovative communication system that allows you to read the complete contents of the ECU without having to open it. Only the power and data signal wires need to be connected on the ECU connector (pinout).
There are connection operation manuals for each control unit.
- Micro reading and writing
- EEPROM reading and writing
- External flash reading and writing (where present)
DFOX calculates and corrects the Checksum of the file and performs the necessary checks to avoid any risk, before programming the vehicle’s ECU.
This simplifies the work as there is no need to open the cover of the control unit and damage to the electric board can be avoided.
Working in BENCH MODE with DFOX
Bench mode is a simple and innovative communication system that allows you to read the complete contents of the ECU without having to open it. Only the power and data signal wires need to be connected on the ECU connector (pinout).
There are connection operation manuals for each control unit.
- Micro reading and writing
- EEPROM reading and writing
- External flash reading and writing (where present)
DFOX calculates and corrects the Checksum of the file and performs the necessary checks to avoid any risk, before programming the vehicle’s ECU.
This simplifies the work as there is no need to open the cover of the control unit and damage to the electric board can be avoided.
The advantages of DFOX for BENCH MODE.
The BENCH MODE connection allows you to read and write the ECU of different types of vehicles. In particular, with this type of connection it is possible:
act on microprocessor (internal flash) and EEPROM; if present also external flash and external EEPROM. Most ECUs can be cloned by transferring the entire contents from the old to the new. For control units with the TRICORE TC17xx processor, there are numerous “clone service” functions in the software that allow adaptation of OTP zones and password zones. In this way, the cloned ECU will have a file consistent with the characteristics of the processor firmware.
The vehicle list is constantly updated, along with the internal functions of the software.
For reading and writing ECUs in BENCH MODE, DFOX is a professional tool that is simple and intuitive to use.
Looking for a tool for reading and remapping ECUs in BENCH MODE? Discover DFOX: one tool for every need!
Contact us to learn more!
Contact us for more information
About our services!
© 2022 | All rights reserved | DFB TECHNOLOGY S.R.L. Via Monte Grappa, 12, 35030 Selvazzano Dentro (PD) | P.IVA e C.F. 05240760289 | Sviluppato da DFB Technology